PuckTransducerMountingInstructions
TrollingMotorMounting
To attach a Puck style transducer to a trolling
motor use the large cable tie provided. Notice
theslotsinthetransducerforthispurpose.
Locate the transducer on the bottom of the
lower unit. Run the cable up the shaft using
smallercabletiestoholditinposition.
Makesurethatthemotionsofthetrollingmotor
will not damage the cable. Plug the transducer
connectorintothebackoftheunitandscrewthe
retainingringdowntight.
InHullMounting
Findingthebestlocationforthetransducerbeforeyoumountitiscritical.
Chooseaflatsmoothspotnearthecenterofthebilgeandneartheback
oftheboat.Itisagoodideatomakea"testrun"beforeyoupermanently
install the transducer to make sure that you can indeed get a reading
throughyourhullandwhentheboatisonplane.Putaboutahalfinchof
water inthe bilge and holdthe transducer in the intended location. Move
thetransducerarounduntilyougetthebestreading.Markthatspot.
To install the transducer clean the spot of mud
and oil. Using an epoxy or silicone glue make a
puddle about the same diameter as the
transducer on the hull. Place the transducer in
the glue. Press it down firmly, gently twisting it
back and forth, making sure that there are no
air bubblesinthe glue betweenthe transducer and the hull.Letthe glue
drycompletelybeforeturningtheuniton.
Run the transducer cord up to the unit taking the same care as you did
whenyouranthepowercord.Plugthetransducerconnectorintotheback
oftheunitandscrewtheretainingringdowntight.
Home•Products•Accessories•Wear•Support•ProStaff•Extras
Commentaires sur ces manuels