Vexilar FL-22 Manuel d'utilisateur télécharger pdf (Page 32)

BOAT INSTALLATION

Mounting the Flasher Unit

Take a few minutes to plan your installation. The unit should be mounted in a location

where it will be readily visible yet out of the way of trafﬁc. The mounting surface should be

fairly at. Be sure to allow clearance for the cables at the rear of the unit while it tilts and

swivels. The unit is weather-proof, not waterproof, so try not to mount it in a location where

it will be exposed to the extreme forces of wave impact during severe conditions.

to i n S t a L L t h e F L a S h e r U n i t :

1. Obtain four appropriate fasteners for your mounting location.

2. Remove the asher unit from the gimbal bracket by removing the two gimbal knobs

on each side of the unit.

3. Position the bracket in your intended

mounting location.

4. Mark the four holes and drill each

using the appropriate drill size.

5. Attach the gimbal bracket using your

four fasteners. Tighten securely.

6. Replace the asher unit into the

gimbal bracket and tighten the

gimbal knobs snuggly.

Power Connection

Your asher unit requires a 12 volt power source to operate. A connection can be made

directly to a battery or a connection can be tapped into a boat’s electrical system.

• If possible, power your asher using the main starting battery, not a battery that

powers an electric trolling motor.

• When routing the cable, be sure to stay away from, or provide cable protection

around, areas with sharp metal edges.

• If the supplied power cord is too short, extend it using 18 gauge wire.

• IMPORTANT: Be sure to have circuit protection, such as a 1 amp fuse or circuit

breaker, placed in the positive line near the power source to protect the wiring.

to C o n n e C t t h e F L a S h e r t o p o w e r :

1. Be sure the power cord is not connected to the asher.

2. Route the power cable from the asher location to the power source.

3. Connect the white or red wire to the positive power source terminal and the black

wire to the negative terminal.

4. Connect the power plug to the asher’s power jack.

Flasher Unit

Rubber

Washer

Gimbal Knob

Gimbal Bracket

Flasher Unit Assembly

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Pas de commentaire

Vexilar FL-22 Manuel d'utilisateur Page 32