Vexilar FL-22 Manuel d'utilisateur télécharger pdf (Page 37)

Installation Procedures

in S t a L L i n G t h e aL U m a dU C e r

1. Using the supplied Scotch-Brite® pad, remove any paint, dirt or coatings on the

aluminum. You MUST be down to the bare aluminum and the surface must be dry.

Wipe off all loose dust and dirt.

2. Using the supplied alcohol swab, wipe clean any dust or dirt you created from

the target area on the hull and the face of the transducer. Use additional cleanup

measures if required. Dry the area with a clean paper towel or rag.

3. Set the transducer in the prepared area and place

the four supplied foam positioning pads around the

transducer as shown. This will keep the transducer

from moving once the transducer has been

positioned.

4. Using the pre-measured packet, mix both elements of

the A.C.E. adhesive together, following the directions

on the packet. Once thoroughly mixed, you have

about 10 minutes to apply this special

A.C.E. Adhesive. (Accoustically Conductive Epoxy)

5. Remove transducer from the target spot. Apply the mixture to the transducer NOT

the boat. Be sure to use all the Epoxy in the packet.

6. Now, simply press the transducer back into the prepared area. Twist it slightly

back and forth several times. This is done to make sure no air pockets remain

under the transducer.

The special A.C.E. Adhesive will set

in about 30 minutes. Try not to move

the boat around during this period.

The foam pads you placed around

the transducer keep it from drifting

from the spot you have selected while

the adhesive cures overnight. Do not

turn your sonar “on” for 12 hours to

ensure a solid connection between the

transducer and the aluminum hull.

IMPORTANT: The hull temperature should be at least 60° F for proper curing of the A.C.E.

adhesive.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Pas de commentaire

Vexilar FL-22 Manuel d'utilisateur Page 37